LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Power Steering) >> Repair Instructions >> Power Steering Pump Shaft Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power steering pump from the vehicle. Refer to Power Steering Pump Replacement  .
    Fig 1: View Of Power Steering Pump & Shaft Seal
    GM1555824Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use the shim stock in order to protect the drive shaft.
  2. Use a chisel in order to cut and remove the power steering pump shaft seal.
scientia non olet · About LEMON Manuals