LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Power Steering) >> Repair Instructions >> Power Steering Pump Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Power Steering Pump & Shaft Seal
GM1555824Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the new power steering pump shaft seal with power steering fluid.
  2. Use a deep 1 inch tall socket in order to install the new power steering pump shaft seal.
  3. Install the power steering pump. Refer to Power Steering Pump Replacement  .
scientia non olet · About LEMON Manuals