LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Power Steering) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position a drain pan under the vehicle.
    2. Fig 1: View Of Power Steering Gear Inlet Pipe/Hose At Brake Booster
    GM1830867Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: When pipes/hoses are disconnected, plug or cap all openings of components during service. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
  2. Remove the power steering gear inlet pipe/hose from the brake booster. Discard the O-ring seal.
    3. Fig 2: Power Steering Gear Inlet Pipe/Hose At Power Steering Gear
    GM1830857Courtesy of GENERAL MOTORS CORP.
  3. Remove the power steering gear inlet pipe/hose from the power steering gear. Discard the O-ring seal.
  4. Remove the power steering gear inlet pipe/hose from the vehicle.
scientia non olet · About LEMON Manuals