LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Power Door Lock System And Release Systems) >> Repair Instructions >> Front Side Door Outside Handle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the door window in the full up position.
  2. Remove the front side door trim. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the front side door pull handle bracket.
  4. Remove the front side door water deflector.
    5. Fig 1: Rear Side Door Handle Rod Clip
    GM2790594Courtesy of GENERAL MOTORS COMPANY
  5. Use the appropriate tool, open the front side door handle rod clip (1) on the latch.
    6. Fig 2: Retaining Tabs
    GM2790591Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    The clip for the outside door handle rod is designed for one use only, a new clip Must be installed to the door latch to retain the outside handle rod.

    NOTE:

    Use the appropriate tool to push in on the retaining tabs located on each side of the old clip to remove.

  6. Remove the old outside door handle rod clip (1) from the door latch.
  7. Remove the door lock key cylinder rod from the handle.
  8. Remove the front side door outside handle bolts (3).
  9. Remove the front side door outside handle from the door (4).
  10. Remove the door lock key cylinder or blank cylinder from the handle. Refer to Door Lock Cylinder Replacement .
scientia non olet · About LEMON Manuals