LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Power Door Lock System And Release Systems) >> Repair Instructions >> Front Side Door Inside Handle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove door upper trim panel. Refer to Upper Extension Trim Panel Replacement (Except Escalade) , Upper Extension Trim Panel Replacement (Escalade) .
    2. Fig 1: Door Trim Panel
    GM2374589Courtesy of GENERAL MOTORS COMPANY
  2. Pull the door trim panel away from the door and support the bottom of the trim panel on the door panel hooks. Refer to Front Side Door Trim Panel Replacement .
    3. Fig 2: View Of Front Side Door Inside Handle Assembly & Bolts
    GM1693916Courtesy of GENERAL MOTORS COMPANY
  3. Remove the front side door inside handle fasteners (1).
  4. Remove the front side door inside handle assembly (2).
    1. Disconnect the electrical connector.
    2. If replacing the door handle, transfer the heated seat switch or seat adjuster memory switch, if equipped. Refer to Front Seat Heater Switch Replacement , or Driver Seat Adjuster Memory Switch Replacement .
    3. Depress both tabs to remove the front side door cable and pull the cable rearward out of the handle assembly.
scientia non olet · About LEMON Manuals