Front Side Door Window Reveal Molding Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS COMPANY Front Side Door Window Reveal Molding Replacement
| Callout |
Component Name |
|
Preliminary Procedures
- Lower the front side door window to the fully down position.
- Tape off the lower window frame to prevent damage to the door.
- Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement
.
- Remove the outside mirror. Refer to Power Mirror Replacement
.
- Remove the inside door frame garnish molding.
|
| 1 |
Front Side Door Window Reveal Molding Retainer (Qty: 13)
TIP:
If reusing the window reveal molding replace the clips. |
| 2 |
Front Side Door Window Reveal Molding
- Install the reveal molding into the window opening by inserting the bottom edge of the molding through the belt opening of the door. Allow the integral fasteners and clips to clear the door frame.
- Use care not to scratch the paint.
- Fully seat the molding onto the belt flange between the corners. Ensure that the lower attachment clips are aligned the holes in the door frame.
- Install the remaining clips around the window flange.
|