LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Solenoid Cable Replacement (with TP2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Remove the mega fuse cover.
    4. Fig 2: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS COMPANY
  4. Remove the starter solenoid cable nut (1) from the mega fuse stud.
  5. Remove the starter solenoid cable terminal (2) from the mega fuse stud.
  6. Open the starter solenoid cable cover at the positive battery terminal.
  7. Loosen the starter solenoid cable nut (5).
  8. Remove the starter solenoid cable from the positive battery terminal.
  9. Remove the starter solenoid cable clip (4) from the air conditioning (A/C) evaporator tube.
    10. Fig 3: View Of Oil Pan Skid Plate & Bolts
    GM1698082Courtesy of GENERAL MOTORS COMPANY
  10. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  11. For 1500 series vehicles, remove the oil pan skid plate bolts and plate.
    12. Fig 4: View Of Oil Pan Skid Plate & Bolts
    GM1698083Courtesy of GENERAL MOTORS COMPANY
  12. For 2500 series vehicles, remove the front 2 oil pan skid plate bolts, loosen the rear 2 bolts and remove the skid plate.
    13. Fig 5: View Of Starter Solenoid Cable Clip & Bolt
    GM1702990Courtesy of GENERAL MOTORS COMPANY
  13. Remove the starter solenoid cable clip (1) from the wheelhouse panel.
  14. Remove the starter solenoid cable clip bolt (2) from the frame.
    15. Fig 6: View Of Starter Solenoid Cable & Nut
    GM1699544Courtesy of GENERAL MOTORS COMPANY
  15. Remove the starter solenoid cable nut (1) from the starter.
  16. Remove the starter solenoid cable (2) from the starter.
  17. Lower the vehicle.
    18. Fig 7: View Of Starter Solenoid Cable
    GM1702991Courtesy of GENERAL MOTORS COMPANY
  18. Remove the starter solenoid cable from the vehicle.
scientia non olet · About LEMON Manuals