LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Battery Jumper Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Mega Fuse Cover
    GM1702800Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Remove the mega fuse cover.
    4. Fig 2: View Of Generator Battery Jumper Cable & Components
    GM1699546Courtesy of GENERAL MOTORS COMPANY
  4. Remove the generator battery jumper cable to mega fuse nut (3).
  5. Remove the generator battery jumper cable terminal (4) from the mega fuse stud.
  6. Remove the generator battery jumper cable clip (2) from the air conditioning (A/C) evaporator tube.
  7. Remove the generator battery jumper cable clip (1) from the stud.
    8. Fig 3: View Of Battery Jumper Cable Terminal, Nut & Bolt
    GM1702914Courtesy of GENERAL MOTORS COMPANY
  8. Reposition the generator battery jumper cable boot (3).
  9. Remove the generator battery jumper cable nut (2) from the generator.
  10. Remove the generator battery jumper cable terminal (1) from the generator stud.
    11. Fig 4: View Of Generator Battery Jumper Cable
    GM1702992Courtesy of GENERAL MOTORS COMPANY
  11. Remove the generator battery jumper cable from the vehicle.
scientia non olet · About LEMON Manuals