LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection and Connection >> Connect Procedure

Connect Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Refer to Battery Disconnect Warning .

    NOTE:

    Clean any existing corrosion from the battery terminal and the battery cable end.

  1. Position the negative battery cable to the battery.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the negative battery cable onto the battery terminal.
  3. Tighten the negative cable nut (6)

    Tighten 

    Tighten the nut to 5 N.m (44 lb in).

  4. Close the hood.
scientia non olet · About LEMON Manuals