LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Steering Wheel And Steering Column) >> Repair Instructions >> Turn Signal Switch Cancel Cam Position Plate Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the inflatable restraint steering wheel module coil and the inflatable restraint steering wheel module coil wave washer. Refer to Steering Wheel Airbag Coil Replacement .
    2. Fig 1: View Of Steering Column Shaft Assembly Components
    GM1702353Courtesy of GENERAL MOTORS COMPANY
    IMPORTANT:

    DISCARD the old steering shaft lock plate ring.

  2. Remove the following parts from the steering shaft:
    1. Steering shaft lock plate retaining ring (1) using J 23653-SIR  steering column lock plate compressor and J 42137  cam orientation plate adapter.
    2. Turn signal switch cancel cam position plate (2)
    3. Turn signal switch cancel cam (3)
scientia non olet · About LEMON Manuals