LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Shaft Upper Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Upper Bearing Assembly
    GM1562300Courtesy of GENERAL MOTORS COMPANY
  1. Install the steering shaft upper bearing to the steering column tilt head assembly.
    2. Fig 2: View Of Steering Column Tilt Head Assembly & Steering Column
    GM1730627Courtesy of GENERAL MOTORS COMPANY
  2. Install the steering column shaft assembly.
  3. Maneuver and push the steering column tilt head assembly (1) towards the steering column in order to lock the steering wheel lock shoes in place.
    4. Fig 3: View Of Pivot Pins At Steering Column Assembly
    GM299893Courtesy of GENERAL MOTORS COMPANY
  4. Lubricate the pivot pins (1) with GM P/N 12346293 (Canadian P/N 992723).
  5. Firmly seat each pivot pin (1) into the steering column tilt head assembly.
  6. Stake the steering column in 3 locations around each pivot pin.
  7. Install J 42640  steering column anti-rotation pin.
    8. Fig 4: Identifying Steering Column Shaft Assembly Components
    GM664265Courtesy of GENERAL MOTORS COMPANY
  8. Install the following parts onto the steering column shaft assembly:
    1. Lubricate the steering shaft upper bearing inner race (1) with GM P/N 12345718 (Canadian P/N 10953516).
    2. The steering shaft upper bearing inner race (1)
    3. The steering shaft upper bearing inner race seat (2)
    4. The steering shaft upper bearing spring (3)
    5. Lubricate the turn signal switch cancel cam (4) with GM P/N 12377900 (Canadian P/N 10953529).
    6. The turn signal switch cancel cam (4)
    7. The turn signal switch cancel cam position plate (5)
    9. Fig 5: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS COMPANY
  9. Install the new steering shaft lock plate retaining ring onto the steering shaft using compressor J 23653-SIR  steering column lock plate compressor and J 42137  cam orientation plate adapter.
  10. Install the automatic transmission control assembly. Refer to Transmission Control Replacement .
  11. Install the tilt spring. Refer to Steering Column Tilt Spring Replacement .
  12. Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  13. Install the turn signal multifunction switch. Refer to Turn Signal Multifunction Switch Replacement .
  14. Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Airbag Coil Replacement .
  15. Install the steering column. Refer to Steering Column Replacement (Without HP2) , Steering Column Replacement (HP2) , Steering Column Replacement (Without HP2 With Electric Tilt Column) .
scientia non olet · About LEMON Manuals