LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Shaft Coupling Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    If a new steering shaft coupling is being installed then transfer the position of the alignment marks from the old component to the same locations on the new component. Failure to transfer the alignment marks may result in an off-center steering wheel after installation.

  1. Install the steering shaft coupling to the vehicle.
    2. Fig 1: View Of Upper & Lower Intermediate Shafts & Components
    GM1701888Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the steering shaft coupling nut (1) and bolt (2) at the upper intermediate steering shaft and tighten to 50 N.m (37 lb ft).
  3. Install the steering shaft coupling bolt at the steering gear and tighten to 47 N.m (35 lb ft).
  4. Install the engine shield. Refer to Engine Shield Replacement .
    5. Fig 2: Locking/Unlocking Steering Column
    GM333146Courtesy of GENERAL MOTORS COMPANY
  5. Remove the J 42640  anti-rotation pin from the steering column lower access hole.
scientia non olet · About LEMON Manuals