LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 454 (Steering Wheel And Steering Column) >> Diagnostic Information and Procedures >> DTC B2850, B2855, B2870, or B2875 >> Component Testing

Component Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Tilt Switch

  1. Ignition OFF, disconnect the harness connector at the tilt switch.
  2. Test for infinite resistance between the control terminals A and C with the switch in the neutral position.
    • If less than the specified range, replace the tilt switch.
  3. Test for less than 1 ohm between the control terminals listed below and the B+ terminal B with the switch in each appropriate position.
    • Tilt Up Switch terminal C
    • Tilt Down Switch terminal A
    • If greater than the specified value, replace the tilt switch.
scientia non olet · About LEMON Manuals