LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 452 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> DTC P2068 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the secondary fuel level sensor.
  2. Ignition OFF, test for less than 1 Ω between the low reference circuit terminal B and ground.
    • If greater than the specified range, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, install a 3 A fused jumper wire between the secondary signal circuit terminal C and the low reference circuit terminal B. Verify the scan tool Fuel Tank Level Remaining parameter display is greater than 98 percent.
    • If less than the specified range, test the secondary signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the secondary fuel level sensor.
scientia non olet · About LEMON Manuals