LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 452 (Instrument Panel System Displays And Gauges) >> Diagnostic Information and Procedures >> DTC P0462 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the fuel level sensor.
  2. Ignition ON, verify that the scan tool Fuel Tank Level Remaining parameter is less than 4 percent.
    • If greater than the specified range, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the ECM.
  3. If all circuits test normal, test or replace the fuel level sensor.
scientia non olet · About LEMON Manuals