Parking Brake Shoe Replacement (1500 Series)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Park Brake Shoe & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to Brake Dust Warning . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the brake rotor. Refer to Rear Brake Rotor Replacement (1500 Series) , Rear Brake Rotor Replacement (2500 Series) . Disconnect the park brake cable from the actuator.
1	Park Brake Shoe Retaining Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 15 N.m (11 lb ft) TIP: Use the appropriate cleaner to clean the work area.
2	Park Brake Shoe Retaining Clip (Qty: 2) TIP: If the retaining clips are found to be damaged, replace the retaining clips.
3	Park Brake Shoe and Lining Turn the park brake shoe adjuster screw until it is fully retracted. When removing or installing the park brake shoe, place the open end of the park brake shoe over the axle flange and rotate it until the shoe has cleared the flange. When installing the park brake shoe, apply a small amount of brake lubricant to the brake shoe and the backing plate contact points. Adjust the park brake shoe. Refer to Parking Brake Adjustment (1500) , Parking Brake Adjustment (2500) .