Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Position the parking brake cable to the vehicle.
- Connect the parking brake cable eye (1) to the parking brake actuator lever.
- Install the parking brake cable to the cable bracket by compressing the parking brake cable spring toward the cable eye and passing the cable through the cable bracket slot.
- Ensure the parking brake cable conduit is fully seated in the cable bracket.
- Install the bolt (1) to the parking brake cable bracket and tighten to 22 N.m (16 lb ft).
- Install the parking brake cable (1) to the retaining clip on the rear axle housing cover.
- Feed the parking brake cable through the parking brake cable guide (1) on the left frame rail over the rear axle.
- Feed the parking brake cable through the parking brake cable guide (1) on the left frame rail.
- Pull the parking brake equalizer forward and install the right parking brake cable connector (1) to the intermediate parking brake cable.
- Compress the locking tabs on the right parking brake cable conduit (2) and install the parking brake cable to the equalizer.
- Adjust the parking brake. Refer to Parking Brake Adjustment (1500) , Parking Brake Adjustment (2500) .
CAUTION:
Refer to Fastener Caution .