LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side (1500) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Intermediate Park Brake Cable Equalizer Nut
    GM2412796Courtesy of GENERAL MOTORS COMPANY
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Loosen the intermediate park brake cable equalizer nut (1).
    4. Fig 2: Identifying Right Rear Park Brake Cable
    GM2412800Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the right rear park brake cable (1) from the equalizer.
  5. Release the right rear park brake cable from the frame bracket by compressing the locking tabs and pulling the cable conduit rearward.
  6. Release the park brake cable from the park brake cable guides on the vehicle frame.
    7. Fig 3: View Of Park Brake Cable & Cable Guides (W/O RPO NYS - 15 Series)
    GM555749Courtesy of GENERAL MOTORS COMPANY
  7. Remove the park brake cable from the track bar clips.
    8. Fig 4: View Of Correct Park Brake Cable Route
    GM1688697Courtesy of GENERAL MOTORS COMPANY
  8. Remove the park brake cable from the actuator lever.
  9. Remove the cable from the backing plate by depressing the locking tabs.
  10. Remove the cable from the retaining bracket.
  11. Remove the park brake cable.
scientia non olet · About LEMON Manuals