LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side (2500) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Identifying Parking Brake Equalizer Adjuster Nut
    GM2401179Courtesy of GENERAL MOTORS COMPANY
  3. Remove the parking brake equalizer adjuster nut (1).
    4. Fig 2: Identifying Left Rear Parking Brake Cable Retainer
    GM2401183Courtesy of GENERAL MOTORS COMPANY
  4. Compress the locking tabs and release the left rear parking brake cable retainer (1) from the frame.
    5. Fig 3: Parking Brake Cable
    GM2808797Courtesy of GENERAL MOTORS COMPANY
  5. Pull the parking brake cable through the parking brake cable guides (1) on the left frame rail.
    6. Fig 4: Parking Brake Cable Bracket Bolt
    GM2808802Courtesy of GENERAL MOTORS COMPANY
  6. Remove the parking brake cable bracket bolt (1).
    7. Fig 5: Identifying Parking Brake Cable Eye
    GM2401089Courtesy of GENERAL MOTORS COMPANY
  7. Disconnect the parking brake cable eye (1) from the parking brake actuator lever.
  8. Release the parking brake cable locking tabs, remove the parking brake cable from the cable bracket by compressing the parking brake cable spring toward the cable eye and passing the cable through the cable bracket slot.
  9. Remove the parking brake cable.
scientia non olet · About LEMON Manuals