LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side (1500) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Intermediate Park Brake Cable Equalizer Nut
    GM2412796Courtesy of GENERAL MOTORS COMPANY
  1. Ensure the park brake is released.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Loosen the intermediate park brake cable equalizer nut (1).
    4. Fig 2: Identifying Left Rear Park Brake Cable
    GM2412798Courtesy of GENERAL MOTORS COMPANY
  4. Disconnect the left rear park brake cable (1) from the intermediate park brake cable equalizer.
  5. Release the left rear park brake cable from the frame bracket by compressing the cable conduit tabs and pulling the cable assembly rearward.
  6. Release the park brake cable from the park brake cable guides on the vehicle frame.
    7. Fig 3: Brake Cable Conduit And Park Brake Cable Eye
    GM1850955Courtesy of GENERAL MOTORS COMPANY
  7. Remove the park brake cable (1) from the bracket by compressing the locking tabs.
  8. Disconnect the park brake cable eye (2) from the park brake actuator lever.
  9. Remove the park brake cable from the vehicle.
scientia non olet · About LEMON Manuals