Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the front brake cable through the hole in the front floor panel and seat the pass-through grommet.
- Position the floor carpet to the floor pan.
- Position the park brake pedal assembly on the side panel.
- Install and finger tighten the mounting nuts. Tighten the nuts to 25 N.m (18 lb ft).
- Connect the park brake warning lamp connection.
- Install the park brake release handle to the instrument panel.
- Install the park brake release handle bolt and tighten to 9 N.m (80 lb in).
- Install the hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
- Install the left side instrument panel electrical center/junction block. Refer to Instrument Panel Electrical Center or Junction Block Replacement - Left Side .
- Raise the vehicle.
- Install the front park brake cable to the frame and press the retainer into place.
- Connect the front park brake cable to the front to intermediate park brake cable connector.
- Lower the vehicle.
- Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
- Adjust the park brake. Refer to Parking Brake Adjustment (1500) , Parking Brake Adjustment (2500) .
NOTE:
Ensure the grommet for the front park brake cable is properly seated in the front floor panel.
CAUTION:
Refer to Fastener Caution .