LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Parking Brake System) >> Repair Instructions >> Parking Brake Intermediate Cable Replacement (2500) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    3. Fig 1: Identifying Right Parking Brake Cable Connector
    GM2401186Courtesy of GENERAL MOTORS COMPANY
  3. Drill a 3 mm (1/8 in) hole through the dimple in the right parking brake cable connector (1) where the front parking brake cable is connected.
  4. Pull the parking brake equalizer forward and disconnect the right rear parking brake cable connector from the front parking brake cable.
    5. Fig 2: Identifying Parking Brake Cable
    GM2401210Courtesy of GENERAL MOTORS COMPANY
  5. Drill a 3 mm (1/8 in) hole through the dimple in the intermediate parking brake cable connector where the front parking brake cable (1) is connected.
  6. Disconnect the front parking brake cable from the intermediate parking brake cable.
  7. Remove the intermediate parking brake cable.
scientia non olet · About LEMON Manuals