LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Parking Brake System) >> Repair Instructions >> Parking Brake Adjustment (2500) >> Cable Tension Adjustment

Cable Tension Adjustment

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel nuts.
  2. Install the brake caliper and bracket assemblies. Refer to Rear Brake Caliper Bracket Replacement (1500 Series) , Rear Brake Caliper Bracket Replacement (2500 Series) .
  3. Install the tire and wheel assemblies Refer to Lifting and Jacking the Vehicle .
  4. With the aid of an assistant, rotate both rear tire and wheel assemblies while slowly tightening the park brake cable adjustment nut.
  5. Tighten the adjustment nut until both rear tire and wheel assemblies cannot be rotated.
  6. Slowly loosen the park brake cable adjustment nut while simultaneously attempting to rotate the rear tire and wheel assemblies.
  7. When the rear tire and wheel assemblies just begin to move, loosen the park brake cable adjustment nut the additional number of turns specified:

    Specification 

    10 additional turns

scientia non olet · About LEMON Manuals