LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Suspension General Diagnosis) >> Diagnostic Information and Procedures >> Trim Height Inspection >> Z Height Measurement

Z Height Measurement

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lift the front bumper of the vehicle up about 38 mm (1.5 in).
  2. Suddenly remove your hands.
  3. Allow the vehicle to settle into position.
  4. Repeat this jouncing operation 2 more times.
    5. Fig 1: Identifying Pivot Bolt Center Line Alignment To Lower Corner Of Steering Knuckle (2WD)
    GM160498Courtesy of GENERAL MOTORS CORP.
  5. Measure from the pivot bolt center line (3) down to the lower corner (5) of the lower ball joint (1) in order to obtain the Z height measurement (4).
  6. Push the front bumper of the vehicle down about 38 mm (1.5 in).
  7. Suddenly remove your hands.
  8. Allow the vehicle to rise.
  9. Repeat the operation for a total of 3 times.
  10. Measure the Z dimension.
  11. The true Z height dimension number is the average of the high and the low measurements. Refer to Trim Height Specifications .
scientia non olet · About LEMON Manuals