Sunroof Panel/Window Garnish Molding Replacement (Crew Cab)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Garnish Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	Sunroof Panel/Window Garnish Molding Assembly Tilt molding approximately 45 degrees with rear end up. Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs. Grab front of molding at centerline and pull rearward approximately 1 inch. Push front edge up, locking front tabs in place. Push up on outboard edges of molding to secure. After molding is secured, slide the molding forward until it stops.

Callout

Component Name

Sunroof Panel/Window Garnish Molding Assembly

Tilt molding approximately 45 degrees with rear end up.
Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs.
Grab front of molding at centerline and pull rearward approximately 1 inch.
Push front edge up, locking front tabs in place.
Push up on outboard edges of molding to secure.
After molding is secured, slide the molding forward until it stops.