LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 447 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Mode Door Replacement - Upper >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The upper mode door is serviced with the upper HVAC module case.

    Fig 1: Heat Stakes
    GM2008728Courtesy of GENERAL MOTORS COMPANY
  1. Remove the HVAC module. Refer to Air Conditioning and Heater Module Assembly Removal and Installation (Non-HP2) , Air Conditioning and Heater Module Assembly Removal and Installation (HP2) .
  2. Disconnect the electrical connector from the mode actuator.
  3. Remove the screws from the mode actuator.
  4. Remove the mode actuator from the HVAC module assembly (1).
  5. If equipped remove the heat stakes (1) from the HVAC module (2) with a screwdriver and a hammer.
    6. Fig 2: Exploded View Of HVAC Module Assembly
    GM962571Courtesy of GENERAL MOTORS COMPANY
  6. If equipped remove the HVAC module assembly screws.
  7. Separate the HVAC module assembly.
  8. Remove the lever (7) from the upper mode door/upper HVAC module case (6).
scientia non olet · About LEMON Manuals