LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 447 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Blower Motor
    GM382496Courtesy of GENERAL MOTORS COMPANY
  1. Install the blower motor.
    2. Fig 2: Turning Blower Assembly Clockwise (Delphi)
    GM382498Courtesy of GENERAL MOTORS COMPANY
  2. Install the blower motor to the heater/ventilation module. Turn the blower assembly clockwise until the retaining tab locks into place.
  3. Install the blower motor insulating cover.
  4. Connect the electrical connector to the blower motor.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the blower motor insulating cover screws and tighten to 1.6 N.m (14 lb in).
  6. If equipped, install the sound insulator panel. Refer to Instrument Panel Insulator Replacement (Cadillac) , Instrument Panel Insulator Replacement (Except Cadillac) .
scientia non olet · About LEMON Manuals