Air Inlet Assembly Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Air Inlet Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the HVAC module assembly. Refer to Air Conditioning and Heater Module Assembly Removal and Installation (Non-HP2) , Air Conditioning and Heater Module Assembly Removal and Installation (HP2) . Disconnect the electrical connector from the recirculation actuator.
1	Recirculation Actuator Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 1.5 N.m (13 lb in)
2	Recirculation Actuator
3	Air Inlet Assembly Screw (Qty: 2) Tighten 1.5 N.m (13 lb in)
4	Air Inlet Assembly TIP: Tilt the rear of the air inlet assembly upward to release front mounting tabs.