Installation Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- If replacing the HVAC module, transfer the components from the old HVAC module as necessary.
- Install the HVAC module (3).
- Install the nuts (2) to the HVAC module (3) and tighten to 9 (80 lb in).
- Install the bolts (1) to the HVAC module (3) and tighten to 4 (35 lb in).
- Reposition acoustic foam (if applicable) to original position or cover access hole with equivalent foam tape (1).
- Connect the electrical harness and the ground connections.
- Install the HVAC module drain hose.
- Install the instrument panel. Refer to Instrument Panel Service Positioning (With SLT) , Instrument Panel Service Positioning (Cadillac) .
- Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
- Install the battery. Refer to Battery Replacement .
- Install the accumulator. Refer to Air Conditioning Accumulator Replacement (HP2) , Air Conditioning Accumulator Replacement (Non-HP2) .
- Install the surge tank outlet hose to the heater core.
Firmly push the quick connect onto the heater core pipe until you hear an audible click.
- Install the inlet heater hose to the heater core.
Firmly push the quick connect onto the heater core pipe until you hear an audible click.
- Fill the engine coolant. Refer to Cooling System Draining and Filling (Static Fill) .
CAUTION:
Refer to Fastener Caution .