LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 447 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning and Heater Module Assembly Removal and Installation (HP2) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the engine coolant. Refer to Cooling System Draining and Filling (Static Fill) .
    2. Fig 1: Identifying Heater Hose To Heater Core Fittings
    GM362171Courtesy of GENERAL MOTORS COMPANY
  2. Using the J-43181  heater line qc release tool disconnect the inlet heater hose from the heater core.
    1. Install the J-43181  heater line qc release tool to the heater core pipe.
    2. Close the tool around the heater core pipe.
    3. Firmly pull the tool into the quick connect end of the heater hose.
    4. Firmly grasp the heater hose. Pull the heater hose forward in order to disengage the inlet hose from the heater core.
  3. Using the J-43181  heater line qc release tool disconnect the surge tank outlet hose from the heater core.
    1. Install the J-43181  heater line qc release tool to the heater core pipe.
    2. Close the tool around the heater core pipe.
    3. Firmly pull the tool into the quick connect end of the heater hose.
    4. Firmly grasp the heater hose. Pull the heater hose forward in order to disengage the surge tank outlet hose from the heater core.
  4. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  5. Remove the drive motor generator control module assembly. Refer to Drive Motor Generator Control Module Assembly Replacement .
  6. Remove the battery. Refer to Battery Replacement .
  7. Remove the accumulator. Refer to Air Conditioning Accumulator Replacement (HP2) , Air Conditioning Accumulator Replacement (Non-HP2) .
  8. Remove the instrument panel to the service position. Refer to Instrument Panel Service Positioning (With SLT) , Instrument Panel Service Positioning (Cadillac) .
  9. Remove the HVAC module drain hose.
  10. Disconnect the electrical harnesses and the ground connections from the HVAC module.
    11. Fig 2: Locating Rear Engine Cover
    GM1704876Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure that any wiring harness does not interfere with the drilling process of the rear engine cover.

  11. Locate the rear engine cover (1) on rear of intake manifold.
    12. Fig 3: View Of Engine Cover Access Location
    GM1704878Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Drill an 25.4 mm (1 in.) diameter hole in the rear engine cover (1) to access the HVAC module retaining nut located behind rear engine cover.

  12. Reposition the acoustic foam (if applicable) down from the access location (1).
    13. Fig 4: View Of HVAC Module, Nuts & Bolts
    GM1698730Courtesy of GENERAL MOTORS COMPANY
  13. Remove the nuts (2) from the HVAC module (3).
  14. Remove the bolts (1) from the HVAC module (3).
  15. Remove the HVAC module (3).
scientia non olet · About LEMON Manuals