LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 447 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Cycling Switch Replacement (Non-HP2) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new O-ring seal to the switch. Refer to Air Conditioning O-Ring Seal Replacement .
    2. Fig 1: A/C Low Pressure Switch
    GM660417Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the A/C low pressure switch to the accumulator and tighten to 6 (53 lb in).
  3. Connect the electrical connector to the A/C low pressure switch.
  4. Leak test the fittings of the components using the J-39400-A  halogen leak detector.
scientia non olet · About LEMON Manuals