LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 447 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Conditioning Compressor Oil Balancing (Non-HP2) >> Draining Procedure

Draining Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:

    Drain and measure as much of the refrigerant oil as possible from the removed compressor.

  1. Before draining oil, position the compressor verdically (clutch facing upwards) and let it sit for 1 minute.
  2. Position the compressor horizontally, with the ports facing downward, rotate the clutch and shake the compressor in order to remove as much oil from the compressor as possible.
  3. Drain the oil from both the suction and discharge ports of the removed compressor into a clean, graduated container. Rotate the compressor shaft to assist in draining the compressor.
    4. Fig 1: Draining A/C Refrigerant Oil From Compressor
    GM821777Courtesy of GENERAL MOTORS COMPANY
  4. Measure and record the amount of oil drained from the removed compressor. This measurement will be used during installation of the replacement compressor. Inspect oil drained from removed compressor. Refer to Air Conditioning Compressor Oil Diagnosis 
  5. Properly discard the used refrigerant oil.
scientia non olet · About LEMON Manuals