LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 445 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Malfunction - Passenger >> Circuit/System Verification

Circuit/System Verification

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. With no weight in the passenger seat observe the passenger seat belt status indicator. Turn ON the ignition, the indicator should illuminate for 5 seconds.
    • If the indicator is always ON or always OFF, refer to Indicator Circuit Test.
  2. Ignition ON, monitor the Passenger Seat Belt Switch parameter while connecting and disconnecting the seat belt. The parameter should display Buckled and Unbuckled when changing seat belt states.
    • If the parameter displays incorrectly, refer to Switch Circuit Test.
scientia non olet · About LEMON Manuals