LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 445 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Does Not Retract

Seat Belt Does Not Retract

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Grasp the seat belt and pull it out slowly and evenly from the retractor, do that in 15-25mm (5/8-1in) increments, continuing until the seat belts entire length has been pulled out.
  2. Release the seat belt, and allow the retractor to slowly retract the full length of the seat belt. The seat belt must retract without any additional help.
  3. Additionally, make sure, that the seat belt can be stopped any time while retracting and then resumed while being released again. This must also be possible in all retracting positions.
  4. Should problems be observed in step 3, perform the first two steps 2 more times.
  5. Should the retractor, after performing these steps, not function freely and properly, it is to be replaced with a new part.
scientia non olet · About LEMON Manuals