LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 444 (Instrument Panel Trim And Console Trim) >> Repair Instructions >> Console Rear Trim Plate Replacement

Console Rear Trim Plate Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Front Floor Console End Cap Assembly & Screws
GM1693888Courtesy of GENERAL MOTORS COMPANY
Console Rear Trim Plate Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the front floor console compartment bezel. Refer to Front Floor Console Compartment Bezel Replacement (Except Cadillac) , Front Floor Console Compartment Bezel Replacement (Cadillac) .
  2. Remove the front floor console rear cupholder. Refer to Front Floor Console Cup Holder Replacement (Cadillac) , Front Floor Console Cup Holder Replacement (Except Cadillac) .
1 Front Floor Console Rear Trim Plate Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Front Floor Console Rear Trim Plate Assembly
Procedure 
Disconnect the electrical connectors.
scientia non olet · About LEMON Manuals