LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 443 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Bucket)

Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Bucket)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Riser Finish Covers & Screw
GM1684826Courtesy of GENERAL MOTORS COMPANY
Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Bucket)

Callout Component Name

Preliminary Procedures

  1. Flip and fold the rear seat forward.
  2. Remove the rear seat floor filler trim cover.
1 Rear Seat Riser Finish Cover Screw
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Rear Seat Riser Finish Cover
3 Rear Seat Riser Finish Cover
scientia non olet · About LEMON Manuals