Rear Seat Frame Front Finish Cover Replacement (with HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS COMPANY Rear Seat Frame Front Finish Cover Replacement (with HP2)
| Callout |
Component Name |
|
Preliminary Procedure
- Turn the ignition switch to the off/lock position, remove the ignition key and secure in technicians pocket until procedure is complete.
- Flip and fold the rear seat forward.
|
| 1 |
Rear Seat Frame Outer Finish Cover
Procedure
Pull upward to disengage the retainer clips. |
| 2 |
Rear Seat Riser Finish Cover Procedure
- Pull upward to disengage the 4 retainer clips on the left side of the cover and then disengage the 3 top retainer clips.
- For reinstallation use the 3 locators to align part properly.
- Engage upper and lower front clips to the back edge of rear seat frame front finish cover. To finish installation process move rearward along the cover. Part is properly installed when all edges are aligned with rear seat frame front finish cover.
|
| 3 |
Rear Seat Frame Front Finish Cover Procedure
- Fold the rear seat down and latch in place to access the finish cover.
- Pull forward to disengage the retainer clips.
|