LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 443 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Rear Seat 3rd Row Hinge Finish Cover Replacement

Rear Seat 3rd Row Hinge Finish Cover Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Rear Seat Hinge Finish Cover & Screws And Shoulder Belt Opening Bezel & Screws
GM1683822Courtesy of GENERAL MOTORS COMPANY
Rear Seat 3rd Row Hinge Finish Cover Replacement

Callout Component Name
Preliminary Procedure 
Remove the Rear Seat No. 2 Back Cushion Cover. Refer to 3rd Row Seat Back Cover and Pad Replacement .
1 Rear Seat Hinge Finish Cover Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
2 Rear Seat Hinge Finish Cover
TIP:  Slide the belt out through the slit in the back of the bezel.
scientia non olet · About LEMON Manuals