Driver or Passenger Seat Back Cushion Finish Panel Replacement (without HP2)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS COMPANY Driver or Passenger Seat Back Cushion Finish Panel Replacement (without HP2)
| Callout |
Component Name |
| 1 |
Front Seat Back Cushion Finish Panel Procedure
- On the right and left sides of the upper portion of the seatback panel, insert a flat bladed tool between the seatback panel and the seat back cushion to release the upper retainer tabs on each side.
- Push the tool against the tabs to release.
- Carefully flex the seatback panel outward to slide the top tabs out of the retainer slots.
- On right and left sides of the lower portion of the seatback panel, insert a flat bladed tool between the seatback panel and the seat back cushion to release the retainer tabs.
- Carefully pull back on the seatback panel, all released tabs must be clear of all obstructions.
- Lift up on the panel to remove from the bottom of the seat back frame, using a flat bladed tool to disengage the bottom clips if necessary.
|