Front Side Door Water Deflector Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Side Door Water Deflector

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
1	Front Side Door Water Deflector When replacing the water deflector, if the hexagonal foam seals are present on the part, align the foam seals to holes in the inner panel as shown. Use a flat-bladed tool to separate the bond between the sealer and the door. Use waterproof tape, or 3M 777 or equivalent, if the water deflector is damaged. It will be necessary to replace trim panel retaining clips, if broken. Before replacing the water deflector clean the door adhesive area, using a 50/50 mix of isopropyl alcohol or equivalent.

Callout

Component Name

Preliminary Procedure
Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .

Front Side Door Water Deflector

When replacing the water deflector, if the hexagonal foam seals are present on the part, align the foam seals to holes in the inner panel as shown.
Use a flat-bladed tool to separate the bond between the sealer and the door.
Use waterproof tape, or 3M 777 or equivalent, if the water deflector is damaged.
It will be necessary to replace trim panel retaining clips, if broken.
Before replacing the water deflector clean the door adhesive area, using a 50/50 mix of isopropyl alcohol or equivalent.