LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary Latch Release Cable Replacement

Hood Primary Latch Release Cable Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Hood Latch Release Cable & Nut
GM1670885Courtesy of GENERAL MOTORS COMPANY
Hood Primary Latch Release Cable Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the headlamps. Refer to Headlamp Replacement (Cadillac Escalade) , Headlamp Replacement (Tahoe, Avalanche) , Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid) , Headlamp Replacement (Escalade PLATINUM) , Headlamp Replacement (Non HID) , Headlamp Replacement (Yukon) , Headlamp Replacement (GMC Yukon Two-mode Hybrid) .
  2. Remove the grille support. Refer to Radiator Grille Reinforcement Support Replacement .
  3. Remove the hood release handle. Refer to Hood Primary Latch Release Cable Handle Replacement .
1 Hood Latch Release Cable Nut
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Hood Latch Release Cable
  • Release the cable from the latch assembly and pull through the dash panel.
  • Attach mechanics wire to existing cable to ease installation of the new cable.
scientia non olet · About LEMON Manuals