Adjustment Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- With the endgate closed, determine the amount of adjustment will be needed.
- If adjustment is necessary, remove the endgate. Refer to Endgate Replacement (Avalanche/Escalade EXT) .
- Mark the position of the hinges with a grease pencil.
- Loosen the endgate bolts and adjust the endgate hinges by moving the hinges in the following directions.
- Upward or downward
- Inward or outward
- Reinstall the endgate and determine if any further adjustments are needed.
- When the proper adjustments are set, tighten the hinge bolts to 40 N.m (30 lb ft).
NOTE:
Use a screwdriver to move the adjustment hinge.
CAUTION:
Refer to Fastener Caution .