Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Make note of the routing in order to aid in reassembly.

Raise and support the vehicle.

Fig 1: Rear Axle Vent Hose & Vent Tube

Courtesy of GENERAL MOTORS CORP.

Remove the vent hose (1) from the clip at the top of the rear axle (3).
Remove the vent hose (1) from the vent tube (4).

Fig 2: Rear Axle Vent Hose Clip

Courtesy of GENERAL MOTORS CORP.

Remove the vent hose clip from the frame.

Fig 3: Rear Axle Vent Hose

Courtesy of GENERAL MOTORS CORP.

Remove the vent hose clip (2) from the tab on the filler neck (1).
Remove the vent hose from the vehicle.