Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Axle Vent Hose

Courtesy of GENERAL MOTORS CORP.

Install the vent hose to the vehicle.
- Route the same way as when removed.
- Ensure that the hose is free of kinks and is routed clear of sharp objects.
- Ensure that the vent is not plugged.
Install the vent hose clip (2) to the tab on the filler neck (1).

Fig 2: Rear Axle Vent Hose Clip

Courtesy of GENERAL MOTORS CORP.

Install the vent hose clip to the frame.

Fig 3: Rear Axle Vent Hose & Vent Tube

Courtesy of GENERAL MOTORS CORP.

Install the vent hose (1) to the vent tube (4).
Install the vent hose (1) to the clip at the top of the rear axle (3).
Remove the supports and lower the vehicle.