LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear axle assembly. Refer to Rear Axle Replacement .
  3. Remove the rear axle cover housing and gasket. Refer to Rear Axle Housing Cover and Gasket Replacement .
  4. Remove the axle shafts. Refer to Rear Axle Shaft Replacement .
  5. Remove the brake caliper brackets. Refer to Rear Brake Caliper Bracket Replacement .
  6. Remove the axle shaft seals and the axle shaft bearings. Refer to Rear Axle Shaft Seal and/or Bearing Replacement .
  7. Remove the differential assembly. Refer to Drive Pinion and Ring Gear Replacement .
  8. Remove the drive pinion shaft yoke and the seal. Refer to Drive Pinion Flange/Yoke and/or Oil Seal Replacement .
  9. Remove the drive pinion. Refer to Drive Pinion and Ring Gear Replacement .
scientia non olet · About LEMON Manuals