LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new drive pinion bearing cups into the axle housing. Refer to Drive Pinion Bearings Replacement .
  2. Install the drive pinion. Refer to Drive Pinion and Ring Gear Replacement .
  3. Install the differential assembly. Refer to Drive Pinion and Ring Gear Replacement .
  4. Adjust the backlash. Refer to Backlash Adjustment .
  5. Adjust the differential side bearing preload. Refer to Differential Side Bearing Preload Adjustment .
  6. Perform a gear tooth contact pattern check. Refer to Gear Tooth Contact Pattern Inspection .
  7. Install the new axle shaft bearings and the axle shaft seals. Refer to Rear Axle Shaft Seal and/or Bearing Replacement .
  8. Install the brake caliper brackets. Refer to Rear Brake Caliper Bracket Replacement .
  9. Install the axle shafts. Refer to Rear Axle Shaft Replacement .
  10. Install the rear axle housing cover and gasket. Refer to Rear Axle Housing Cover and Gasket Replacement .
  11. Install the rear axle. Refer to Rear Axle Replacement .
  12. Lower the vehicle.
scientia non olet · About LEMON Manuals