Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the gasket (3) and the rear axle housing cover.
- Install the jounce hose bracket with a new bolt (1) and the new brake pipe/harness bracket stud (2) in their proper locations. Do not tighten.
- Install the remaining new rear axle housing cover bolts.
Tighten: Tighten all the rear axle housing cover bolts in a crosswise pattern to 40 N.m (30 lb ft).
- Install the brake pipe/harness bracket and nut to the stud.
Tighten: Tighten the nut to 40 N.m (30 lb ft).
- Fill the rear axle. Refer to Lubricant Replacement - Rear Drive Axle .
- Lower the vehicle.
IMPORTANT:
Do not reuse the rear axle housing cover bolts.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.