LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Rear Drive Axle) >> Repair Instructions >> Lubricant Replacement - Rear Drive Axle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
    Fig 1: Locating Rear Axle Drain Plug
    GM390113Courtesy of GENERAL MOTORS CORP.
  1. Install the rear axle drain plug.

    Tighten:  Tighten the rear axle drain plug to 33 N.m (24 lb ft).

  2. Fill the rear axle. Use the proper fluid. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations .
    3. Fig 2: Rear Drive Axle Fill Plug
    GM913433Courtesy of GENERAL MOTORS CORP.
  3. Install the rear axle fill plug.

    Tighten:  Tighten the rear axle fill plug to 33 N.m (24 lb ft).

  4. Lower the vehicle.
scientia non olet · About LEMON Manuals