Tail Lamp Replacement (Tahoe, Yukon)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Tail Lamp Replacement (Tahoe, Yukon)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Open the liftgate in order to access the tail lamp assembly screws. |
|
| 1 | Tail Lamp Assembly Screw (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 2 N.m (18 lb in) |
| 2 | Tail Lamp Assembly Locator Pin (Qty: 2) TIP: Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts. |
| 3 | Tail Lamp Retainer Nut (Qty: 2) |
| 4 | Tail Lamp Wiring Harness Assembly Connector |
| 5 | Tail Lamp Assembly TIP: Upon installation, push inward on the tail lamp in order to seat the 2 locating pins. |