Tail Lamp Replacement (GMC Yukon Two-Mode Hybrid)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Tail Lamp Replacement (GMC Yukon Two-Mode Hybrid)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Open the liftgate in order to access the tail lamp assembly screws. |
|
| 1 | Tail Lamp Assembly Screw (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in) |
| 2 | Tail Lamp Electrical Harness Assembly Connector TIP: Disconnect the tail lamp bulb and side marker lamp bulb sockets from the lamp assembly. |
| 3 | Tail Lamp Assembly TIP: Upon installation, push inward on the outer edge of the tail lamp in order to seat the 2 locating pins to the outer body panel nuts. |